Vehicles Coverage: All BMW cars up to the year 2004 which include Personal, Off- Road and Commercial vehicles.
Descriptions: MCU controlled Interface which is compatible with the original Carsoft interface. Fully digital line switchings and MCU controlled service reset timing.
Operates with BMW Scanner 1.3.6 software from PA-Soft to Read and Clear DTCs (fault codes) and also the Read and Edit certain data in the device memories during diagnostic.
Function: This newer version of the BMW-scanner for E38/E39/E46/E53 differs from the previous version (V1.25) on the followings:
- The high-grade program module for work with ZKE (Body Control Module) is added. - Functions of Adaptation second-hand blocks SRS MRS2- MRS4 (in V1.25 - only MRS4) are added. - Support of the diagnostic report of blocks DME of series ME7 is added. - Functions of installation of indications odometer (miles/km) and language of messages BK (GE/EN/FR/IT) are added - The base of support on updating run in IKE and LCM (LCM-4 up to 09.2004) is added.
Features: Operates with BMW Scanner 1.3.5 (and older) software from PA-Soft to Read and Clear DTCs (fault codes) and also the Read and Edit certain data in the device memories during diagnosis.
Function: The new version of the BMW-scanner for E38/E39/E46/E53 differs from the previous version (V1.25) on the followings:
- The high-grade program module for work with ZKE (Body Control Module) is added. - Functions of Adaptation second-hand blocks SRS MRS2- MRS4 (in V1.25 - only MRS4) are added. - Support of the diagnostic report of blocks DME of series ME7 is added - Functions of installation of indications odometer (miles/km) and language of messages BK (GE/EN/FR/IT) are added - The base of support on updating run in IKE and LCM (LCM-4 up to 09.2004) is added
The Diagnostic Tool Set consists of a set of PC based applications which support developers, engineers and technicians in all aspects of communication with ECUs and vehicles via serial communication lines.
Typical applications of this Ediabas / Inpa interface include: - Specification of ECU’s diagnostic data - Communication development - Reading and clearing error memory - Flash data uploading and downloading - Reading measurement values - Input/output control - Calibration of single ECU variables - Coding of ECU variables - Coding of ECU variants - CAN (Controller Area Network) bus mode emulation
D-CAN interface is used to work with software for GT1 and INPA. It has the full functions as GT1 and INPA. The INPA and GT1 software is included. Software is dis52 base+dis55+tis2007.12+dis44(coding+progman). TIS and coding/programm functions all activated now!
